Introduce the basic debugging and operation method of the riveting machine

The basic operation method of the riveting machine and the preparation before operation:

　　  Operation method:

　　 1. The power switch is placed in the "ON" position, and the motor and flywheel are working at this moment.

　　2. Place the material to be riveted in the floating center of the mandrel. After the hole orientation is aligned, put the processed material to perform the riveting action.

　　3. Step on the pedal, release the clutch, make the upper die go from the top dead center to the bottom dead center, riveting the rivet into the hole fixed by the material, and then return to the original top dead center, the cycle ends.

Preparation before homework:

　　 1. Check if the machine is stable.

2. Is the power socket plugged in securely?

　　 3. Adjust the interval of the floating center of the upper mold according to the standard rivets, start the trial mold, and check whether the riveting fits the product models.

　　 4. Turn on the power, try pedaling, if the motor works normally, the preparation is over.

　　 Describes the operation strategy of the riveting machine:

　　 1. Operating procedures:

　　 Step on the pedal of the riveting machine and release the breaker. Using a manual flywheel, rotate the main shaft clockwise to make the upper die move from the top dead center to the bottom dead center, and then return to the top dead center to lock the clutch, that is, a cycle. After the adjustment meets the requirements, manually rotate the spindle clockwise and the upper die does not move, and the adjustment is over.

　　 2. Preparation before homework:

Check whether the machine is stable and whether the power socket is plugged in. Adjust the floating center interval of the upper mold according to the standard rivets. Start the test mold to check whether the riveting fits the commodity machines. Turn on the power supply and try pedaling. If the motor is working normally The preparation is over.

　　 3. Abnormal disposal:

　　 There is a strange noise during operation, so you should stop the machine to check if the motor is hot, and tell the professional to repair it. If the pedal is stepped once during operation and the action is more than two times, it is a normal condition, and you should tell the professional for maintenance.

　　 4. Operation method:

　　 Place the material to be riveted by the riveting machine in the floating center position of the mandrel. After the hole orientation is aligned, put the processed material to perform the riveting action.